Baby Lock Kinetic Frame, Руководство по сборке

Страница: 22 / 28

22 Baby Lock Kinetic Frame Assembly Instructions
Parts needed
(5) pole assembly
(7) pole end
(2) short-bolt ratchet wheel assembly
(1) long-bolt ratchet wheel assembly
(1) hand wheel assembly
(1) hand wheel insert
Tools Required
17/13mm wrench (provided)
Pole end/10mm wrench (provided)
11-1: Check one pole end to ensure that it
matches Fig 11-1 and 11-3.
11-2: Loosen the nut on the pole end until it
reaches the end of the bolt (Fig. 11-2).
11-3: Holding onto the outside pole end, push
the nut end of the bolt towards the opposite
end of the assembly (Fig. 11-1), until the pole
end short-bolt wedge slides out (Fig. 11-2).
This makes the outside diameter of the pole
end smaller and ready to be inserted into the
end of the pole assembly.
11-4: Repeat Steps 11-1 to 11-3 to prepare the
remaining four (6) pole ends for insertion.
NOTE: A pole end wrench is provided to
aid in holding the pole ends without ratchets
and a regular M10 nut is provided for the pole
ends with ratchet wheel assemblies, if you have
trouble holding the pole end while tightening
the pole end into the pole.
11-5: Slide one pole end into the end of one
pole assembly as shown in Fig. 11-4. Check
that the pole end is inserted completely into the
pole assembly.
11-6: Completely tighten the nut, using the
17/13mm wrench, while holding the pole end
assembly tightly into the open end of the pole.
This will expand the outer pole end, ensuring a
tight fit into the pole.
Fig. 11-3
Inside Pole End Short Bolt Wedge
Outside Pole End
Large Washer
V Bearing
Small Washer
Lock Nut
Pole End assembly comes pre-assembled. Exploded diagram is
for reference only.
Fig. 11-4
Fig. 9-1
Fig. 9-2
Fig. 8-1
Fig. 9-4
Fig. 9-3
Fig. 9-1
Fig. 9-2
Fig. 8-1
Fig. 9-4
Fig. 9-3
Pole End
Fig. 9-1
Fig. 9-2
Fig. 8-1
Fig. 9-4
Fig. 9-3
Pole End
Fig. 11-1
Fig. 11-2
Loosen nut then push
Fig. 9-1
Fig. 9-2
Fig. 8-1
Fig. 9-4
Fig. 9-3
Wedge
Slides Out
Step 11
Pole End Assembly