B.A. International BA OPTIMA E+ BAE380R, Инструкция по эксплуатации

Страница: 8 / 26

12 13
e. Preset program selection
Long press Setting button “P” to enter preset program during standby
state, press Adjusting button “+”/“-” to select file system , press Setting
button “P” to entry enter file number selection, press Adjusting button
“+”/“-” to select file number, then press Main button to confirm.
f. Handpiece functions setting
With the motor handpiece turned off, hold down the Setting button “P”
and press Main button to enter handpiece functions setting, press Setting
button “P” to cycle through settings, press Adjusting button “+”/“-” to
adjust, then press Main button to confirm.
3.2 Screen display
Standby interface
a. Customized program sequence
number 0-9, in total 10 programs.
b. Battery consumption
c. Set speed
d. Set torque
e. Operation mode
Working interface
a. Set speed
b. Set torque
c. Real time torque
d. Torque display scale
Canal measurement mode interface
a. Apical reference point flash bar
b. EAL: Electronic apex locator
Main button Display screen Adjusting button"-"
Adjusting button "+"
Setting button "P"
2.7 Installation and removal of disposable isolation sleeves
2.7.1 Installation
Before each use of the handpiece and after the handpiece is cleaned
and disinfected,put on a disposable isolation sleeve. Take the isolation
sleeve out of the isolation sleeve box, then insert the isolation sleeve into
the motor handpiece from the thin end of the handpiece, and install the
isolation sleeve until there is no obvious wrinkle.
After installing the disposable isolation sleeve, wrap the barrier film
around the handpiece surface. After that, clean and disinfect the surface
of the handpiece. Refer to Chapter 6.3 for cleaning and disinfection
procedures.
2.7.2 Removing
After each use, remove the barrier film and slowly pull the isolation
sleeve from the thin end of the handpiece.
Warning: Isolation sleeves are not reusable
3 Function and operation of product
3.1 Button definition and settings
a. Turn power on
Press Main button to turn on motor handpiece.
b. Turn power off
Hold down the Setting button “P”, then press Main button to turn off
motor handpiece.
c. Customized program change
Press Adjusting button “+”/“-” during standby sate.
d. Parameter setting
Press Setting button “P” to cycle through parameters, press Adjusting
button “+”/“-” to change them, then press Main button or wait 5 seconds
to confirm.