B.A. International BA OPTIMA E+ BAE380R, Инструкция по эксплуатации

Страница: 11 / 26

18 19
Rotation starts automatically when the file is
inserted into the canal and the canal length
indicator bar lights up more than 2 bars.
P ress Adjusting button “+”/“-” to change.
OFF: Motor does not start when file is inserted
into the canal. The Main button is used to start
and stop the motor handpiece.
ON: Motor starts automatically.
Rotation stops automatically when the file is
taken out of the canal and the canal length
indicator bar lights up less than 2 bars before the
file is taken out.
Press Adjusting button “+”/“-” to change.
OFF: Motor does not stop when file is taken out
of t he canal. The Main button is used to start
and stop the motor handpiece.
ON: Motor stops automatically.
This is the reference point where various apical
actions are triggered.
Press Adjusting button “+”/“-” to select
reference point by changing the flash bar.
The meter’s 0.5 reading indicates that the file
tip is located very near the physiological apical
foramen.
The reference point (flash bar) can be set from 2
to AP (Apex) on the meter.
Rotation automatically slows down as the file
tip approaches the reference point.
P ress Adjusting button “+”/“-” to change.
OFF: Disable Apical Slow Down function.
ON: Rotation automatically slows down as the
file tip approaches the reference point.
Forward Angle .In the SGP mode, the Forward
Angles of 20°~400° are available.
In the ATR mode, the Forward Angle of
60°~400° are available.
Reverse Angle .In the SGP mode, the Reverse
Angles of 20°~400° are available.
In ATR mode, the reverse Angle cannot be
greater than the forward Angle.
4.4 Preset program selection
For convenience, we preset some common file
system.
Press Adjusting button “+”/“-” to switch to
preset program(M0-M9, preset program 1-5 ),
the interface will show as left.
Long press Setting button “P” to enter preset
program during standby state, the interface will
show as left.
Press Adjusting button “+”/“-” to select file
system.
After selecting file system, press Setting
button “P” to enter file number selection, press
Adjusting button “+”/“-” to select file number,
then press Main button to confirm.