The
AZZA
366 MAINBOARD SERIES
Page 7
CPU Clock Ratio Selection (only available for 366X-AS)
This mainboard comes with an onboard Dip Switch, SW1. SW1 can be used to set the
CPU clock ratio. Note: You can not change the CPU Clock Ratio on all CPU’s. This function
depends on the CPU you are using.
System Memory
The 366 mainboard series uses Double Data Rate Dual Inline Memory Modules (DDR
DIMM). Each mainboard has three 184-pin DIMM sockets. These sockets support 2.5V
(power level) single-sided or double sided PC-1600 or PC-2100 DDR DIMM modules The
maximum memory supported by these mainboards is 3 GB.
Expansion Slots
These mainboards are equipped with five dedicated PCI slots, one CNR slot (not avail-
able for the 366A-BV), which is shared with PCI 5, and one 4x AGP slot.
Onboard Audio Features
Supports Microsoft DirectSound/ DirectSound 3D and AC97 Full Duplex.
Word Size
•
Data Path: 8-bit, 16-bit, 32-bit, 64-bit
•
Address Path: 32-bit
Front Side Bus Frequency (FSB)
For a 200 MHz CPU the mainboard supports a 100 MHz FSB. For a 266 MHz CPU the
mainboard supports a 133 MHz FSB.
BIOS
•
Award BIOS, Windows 95/98 Plug and Play (PnP) compatible.
•
Supports SCSI sequential boot-up.
•
Flash EPROM for easy BIOS upgrades.
•
Supports DMI 2.0 function
Desktop Management Interface (DMI)
Desktop Management Interface (DMI)
The mainboard comes with DMI 2.0 built into the BIOS. The DMI utility in the BIOS will
automatically record different information about your system configuration and store this
information in the DMI pool, which is a part of the system board's Plug and Play BIOS.
DMI, along with the appropriately networked software, is designed for easy inventory,
maintenance and the simplified troubleshooting of computer systems.
WOL (Wake
WOL (Wake
-
-
On
On
-
-
LAN) Port
LAN) Port
One WOL connector supports Wake-On-LAN functionality.
WOM (Wake-On-Modem) Port
One WOM connector supports Wake-On-Modem functionality.
Introduction
