The
AZZA
366 MAINBOARD SERIES
Page 37
SuperIO Device
When you press enter the menu below is shown:
!
Onboard FDC Controller
Select Enabled if your system has a floppy disk controller (FDC) installed on the sys-
tem board and you want to use it. If you install an add-in FDC or the system has no
floppy drive, select Disabled in this field.
!
Onboard Serial Port 1/Port 2
These two selection fields allow you to select the I/O address and corresponding inter-
rupts for the first and second serial ports.
!
UART Mode Select
Your system may offer a variety of infrared modes on the second serial port. The op-
tions are Standard, HPSIR or ASKIR.
!
UART Mode Select
Your system may offer a variety of infrared modes on the second serial port. The op-
tions are Standard, HPSIR or ASKIR.
!
RxD, TxD Active
This field allows you to set the IR reception/transmission polarity as high or low. To
determine which polarity is appropriate you must refer to the documentation for your
IR peripheral.
This field is usually found under the Onboard Serial Port 2 option. If you disable the
Managing The PC BIOS
CMOS Setup Utility - Copyright (C) 1984 - 2001 Award Software
SuperIO Device
Onboard FDC Controller
Onboard Serial Port 1
Onboard Serial Port 2
UART Mode Select
X RxD, TxD Active
X IR Transmission Delay
X UR2 Duplex Mode
X Use IR Pins
Onboard Parallel Port
Parallel Port Mode
X EPP Mode Select
X ECP Mode Use DMA
Game Port Address
Midi Port Address
Midi Port IRQ
Item Help
Menu Level
!!
!!
!!
!!
[Enabled]
[3F8/IRQ4]
[2F8/IRQ3]
[Normal]
Hi, Lo
Enabled
Half
IR-Rx2Tx2
[378/IRQ7]
[SPP]
EPP1.7
3
[201]
[330]
[10]
