The
AZZA
366 MAINBOARD SERIES
Page 20
2.5.9. S/PDIF Connector (optional)
Connector: CN 36
Type: 2 pin
These mainboards come with an optional internal S/PDIF connector. S/PDIF is a digital
interface that can be used to improve the quality of the sound output from your system.
The diagram is on the following page.
1 S/PDIF data input signal
2 Ground
S/PDIF data
input signal
Ground
Front View of the S/PDIF
Top View of the S/PDIF
2.6.1 PW: Power On / Off and External Suspend Switch Connector
The Power On/Off connector has two functions. It can be the Power Switch or Suspend
Switch of your PC system. You can either choose “Delay 4 Sec” or “Instant
OFF” (Please refer to the Award BIOS setup instructions in Chapter 3).
Option 1: If you choose “Delay 4 Sec.” In the BIOS CMOS Setup, the function of “PW”
will be:
A. When the system power is "OFF", press this switch, the system will power on.
B. When system power is "ON”, you can select two different modes: -
Mode 1: Press and hold the Power ON button for less than 4 seconds and then release it.
The system will be turned into Suspend mode (turned into the GREEN mode) When the
system is in the Suspend mode:-
Ground
The following System Panel Buttons and LED
Connectors can be found at the front of the
mainboard on the left hand side.
PW= Power On/Off and
Suspend Switch Connector
SL = Standby LED Connector
HL = HDD LED Connector
RS = Reset Button Connector
2.6. System Panel Buttons and LED Connectors
PIN 1
SL:Standby DC pull up
HL:
+5V DC Pull Up
Ground
RS:
Reset Control
PW:
+5V DC Pull Up
Ground
Ground
Top View of the System Panel
and LED Connectors
Hardware Installation
