The
AZZA
366 MAINBOARD SERIES
Page 14
2.4.2. Memory Modules
These mainboards all have three 184-pin DDR DIMM slots and are able to support a
maximum memory of 3 GB. The DDR DIMM slots are located on the right hand side of the
board. To install the DIMM’s into these slots, make sure the white lever at each side of the
slot has been pulled down to an angle of approximately 45°. Make sure that the DIMM is
in the correct orientation. Place the DIMM on the slot and push down firmly.The white
levers will come back up and lock the module in place.
Important: The DIMM’s can only be fitted into the slots in one orientation.
Make sure that the DIMM’s are in the correct orientation and the pins are cor-
rectly aligned before you insert them.
2.4.1. Installation of the CPU
To install your processor, please complete the following set of instructions
1. Locate a small dot marked on the top of the CPU. This mark indicates Pin 1 of
the CPU.
2. Locate Pin 1 for the Socket on the mainboard.
3.
There is a lever on the side of the socket. First push this lever sideways and
then lift it to a 90-degree angle.
4.
Insert the CPU into the Socket. Please make sure that Pin 1 for the CPU is in-
serted into Pin 1 of the Socket.
5. When the CPU is installed correctly push the lever back into place.
6. Install a proper heat sink with cooling fan for proper heat dissipation.
Failing to install a heat sink with cooling fan may cause overheating which will
burnout your CPU and damage your mainboard.
IMPORTANT: CPU COOLING FAN
Please ensure that you have an approved heat sink with cooling fan. Without a
proper heat sink with cooling fan you will damage both the mainboard and the
CPU.
2.4. CPU, Memory and Expansion Slots
52 pins
40 pins
Top View of a 184-pin DIMM Slot
Hardware Installation
