![background image](http://html1.mh-extra.com/html/ayra/9000-0021-6272/9000-0021-6272_user-manual_3042271010.webp)
DMX:
The IntenZ CB600 can be connected to a DMX controller with standard 3p and 5p XLR male – XLR female
cable. In DMX mode, a DMX terminator must be connected to the last fixture at the end of the DMX chain to
prevent reflections in the DMX signal, which could cause flickering and unwanted behaviour from your
intelligent fixtures.
A DMX terminator is an XLR connector with a 120-ohm resistor placed between pin 2 and 3 as a bridge.
NOTE:
The IntenZ CB600 can be switched between various channel modes. For simple applications where a
minimum amount of control is required, the 1CH mode is perfect. Users who wish to have ultimate control
over all pixels and functions can use the 51CH mode.
1CH mode:
CH
Function
Values
CH1
Sound active
000-255 Sound active
3CH mode:
CH
Function
Values
CH1
Red dimmer 0-100%
000-255 0-100%
CH2
Green dimmer 0-100%
000-255 0-100%
CH3
Blue dimmer 0-100%
000-255 0-100%
All information and illustrations shown in this user manual are subject to change without further notice.
User manual version: 1.0
Creation date + author initials: 13-05-2015 RV Revision date + author initials: