AXIS T8504–E Outdoor PoE Switch
Web interface
Primary server IP address
Configure the primary IPv4, IPv6 or hostname to be used to access the main RADIUS/
server.
Secondary server IP address
Configure the secondary IPv4, IPv6 or hostname to be used to access the main RADIUS/
server.
Timout (Sec)
Configure the time for a reply timeout.
RADIUS extra parameters
Parameter
Description
Authentication UDP port
Configure the UDP port used by the RADIUS server.
extra parameters
Parameter
Description
Authentication TCP port
Configure the TCP port used by the server.
Note
Software version 3.51.06 only supports accessing RADIUS/ servers over IPv4, either with an IPv4 address or a
hostname to be resolved by DNS server.
Test RADIUS/
Go to
Test RADIUS/
to verify the RADIUS/ configuration before activating it.
Note
During testing, the
Enable authentication
should be disabled.
1. Configure all RADIUS/ parameters, leaving the
Enable authentication
disabled.
2. Save the configuration. If not, the parameters will be restored to saved values after each test, erasing any unsaved value.
3. Type the username and password.
4. Click
Test configuration
. A waiting message will appear, followed by either
OK
or
FAIL
.
5. If needed, change and save the configuration and test again.
6. When the test result is OK, set
Enable authentication
to enabled. Save the configuration, which activates the
RADIUS/ configuration.
VLAN configuration
VLAN configuration sanity check is done upon unit power-up and when a VLAN configuration change is requested over the web. The
sanity check is to make sure that the unit remains manageable over the network after VLAN configuration is applied. In case the new
VLAN configuration may cause the unit to become unmanageable, an error message appears on the webpage for requests over the
web. When a problem is detected upon power-up, the unit configuration will be restored to factory default.
VLAN enable & management port
Parameter
Description
Enable VLAN
Enable or disable VLAN functionality.
11
