Axell BSF-3302 61-200001 Series Repeater
Product Description and User’s Manual
© Axell Wireless Ltd
Doc. No. PN 3302 61-200001 Series-UM Rev. 1.0
24
100m
m
8
m
m
d
ia
.
Bolt head
Washer
Sleeve/Anchor
4.2.3 Mount the Repeater on the Wall
The Repeater wall mount brackets assembly should be fixed to a solid wall (these include
brickwork, blockwork, and concrete.);
(Due to the weight of the Repeater, it is NOT recommended to fix to a hollow wall).
Figure 4-3: M8 Rawlbolt
– recommended for wallmount.
Always check that there are no pipes or cables hidden in the wall beneath the
area to be drilled. Various pipe and cable detectors are available for this type
of inspection.
To provide secure fixing to a solid wall, the most common method is drilling and plugging. The size
of fixing is dependent on the item to be fixed and the nature of the wall, The Repeater should be
fixed with mild steel, M8 (100mm) rawlbolts or similar.
1.
Mark out the fixing centers of the repeater on the chosen wall (see 4.2.2).
2.
Mark and drill the wall with the correct size masonry bit as specified by the fixing
manufacturer.
NOTE: It is good practice to wear goggles to protect your eyes from flying debris when using power
tools.
3.
Hold the drill bit against the mark and begin drilling slowly so that the bit does not wander
from the position. The wall should be drilled to a depth which is sufficient to accommodate the
full length of the fixing.
4.
Insert the fixings so that the top of the sleeve/anchor section is level with the wall surface.
Gently tighten the bolt by hand so that the anchor section of the fixing expands and grips the
inside of the hole.
Figure 4-4: Inserting Fixing and Tightening.
