Axell BSF-3302 61-200001 Series Repeater
Product Description and User’s Manual
© Axell Wireless Ltd
Doc. No. PN 3302 61-200001 Series-UM Rev. 1.0
10
Caution:
Safety to equipment
When installing, replacing or using this product, observe all safety
precautions during handling and operation. Failure to comply with the
following general safety precautions and with specific precautions
described elsewhere in this manual violates the safety standards of the
design, manufacture, and intended use of this product.
Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
Axell Wireless assumes no liability for the customer's failure to comply
with these precautions. This entire manual should be read and
understood before operating or maintaining the repeater.
Warning:
Restricted Access
Location
This Axell Wireless equipment is to be installed only in a restricted access
location where access is restricted to SERVICE PERSONNEL and to
USERS who have been instructed on the restrictions and the required
precautions to be taken.
Attention:
Electrostatic
Sensitivity
Observe electrostatic precautionary procedures.
ESD = Electrostatic Discharge Sensitive Device.
Static electricity can be conducted to the semiconductor chip from the
center pin of the RF input connector, and through the AC connector pins.
When unpacking and otherwise handling the repeater, follow ESD
precautionary procedures including use of grounded wrist straps,
grounded workbench surfaces, and grounded floor mats.
Caution:
Class 1 Laser
The repeaters described in this manual are equipped with class 1 lasers,
as per definition in EN 60825-1
Caution!
- Un-terminated optical receptacles may emit laser radiation.
Exercise caution as follows:
●
Do not stare into the beam or view with optical instruments.
Optical transmitters in the fiber optic converter can send out high
energy invisible laser radiation. There is a risk for permanent
damage to the eye.
●
Always use protective cover on all cables and connectors which
are not connected.
●
Never look directly into a fiber cable or a connector.
●
Consider that a fiber can carry transmission in both directions.
●
During handling of laser cables or connections, ensure that the
source is switched off.
●
Regard all open connectors with respect and direct them in a
safe direction and never towards a reflecting surface. Reflected
laser radiation should be regarded as equally hazardous as
direct radiation.
