AWH TANKO JM100, Руководство по эксплуатации и установке, Страница: 92 / 104

Jet Cleaner TANKO-JM
82/90 Translation of the original Operating / Installation Instructions 2016/12 8 Faults
8.2 Faults and Remedial Action
Fault Cause Remedy
Cleaning head and/or
nozzle carrier not rotating
or rotating unevenly. – There is no media pressure on the
device. – Open the shut-off valve for the
medium.
– Pressure of the cleaning agent too
low. – Increase the pressure (adhere to
the max. permitted pressure).
– Pressure of the cleaning agent too
high. – Reduce the pressure.
–
Excessive friction due to wear on
the bushings and/or bearings.
–
Check the bushings and/or
bearings for wear, clean or replace
them.
–
Actuator unit in the device
damaged or contaminated with
deposits or foreign objects. The
teeth of the spur gears jam.
–
Clean the inside of the device and
remove any foreign objects.
Replace the spur gears.
– The cleaning head collides with
installed components. – Eliminate the interfering contours.
–
Nozzles are blocked mechanically
by interfering contours.
–
Check the position in the
container.
– Nozzle jet too close to surrounding
components. Due to high media
pressure (recoil). – Increase the distance to
surrounding components.
– Filter or nozzles blocked. – Clean the filter or nozzles.
Effectiveness of cleaning
is inadequate. – Nozzles soiled or blocked. – Clean or replace the nozzles.
– Pressure of the cleaning agent too
low. – Increase the pressure (adhere to
the max. permitted pressure).
– Volume flow rate too low. – Increase the volume flow rate
–
Filter blocked.
–
Clean or replace the filter.
Jet pattern not ideal. – No jet concentrators in the
nozzles. – Retrofit jet concentrators.
–
Nozzles soiled.
–
Clean the nozzles.
– Nozzles damaged. – Replace the nozzles
Process or media
connection leaking.
–
Seal defective.
–
Replace the seal.
– Connections have come loose. – Check the tightening torque
values of the screw connections.
Volume flow rate too high. – Increased leakage due to heavily
worn bushings or bearings. – Replace the bushings or bearings.
Table 8.2-1: Operating faults
–
cause and remedy
If the specified measures are NOT successful, please contact AWH.
In the event of return shipment (e.g. repair / servicing / return), a hazardous substance
declaration must be enclosed with the device in accordance with the Hazardous Substance
Directive (GefStoffV).
Request the form for the hazardous substance declaration from AWH.