AWH TANKO JM100, Руководство по эксплуатации и установке, Страница: 55 / 104

Jet Cleaner TANKO-JM
6 Commissioning Translation of the original Operating / Installation Instructions 2016/12 45/90
WARNING
Risk of burns from hot surfaces!
The device may heat up significantly as a result of the cleaning fluid or the heat transfer
from the container. Contact with the device can cause burns on the skin.
There is a risk of death or severe physical injuries.

Comply with the warning signs and DO NOT touch the indicated areas.

Do NOT remove insulation from protected hot surfaces.

Maintain safety clearance of existing protective equipment or barriers.

Use protective equipment (e.g. protective gloves; cloths) to provide protection from the
hot surface.

Do not touch the device until after a sufficient cooling time.
The safety systems and safety notes in the operating instructions for the higher-level plant/machine
must be adhered to.
The area around the plant/machine and the operator work stations at the plant/machine must be keep
free of objects during operation so that unobstructed access is possible at all times.
In order to ensure fault-free operation, the device must be treated with care at all times.
When operating the device, adhere to the following additional instructions:
WARNING
Persons in the container. A person may be struck by the jets from the cleaning head!
There is a risk of death or severe physical injuries.

DO NOT start cleaning operation while there are persons in the container.

NEVER direct the cleaning jet at persons.
WARNING
Incorrect operation of the device!
There is a risk of death or severe physical injuries.

Only operate the device when it is in perfect condition.

Do not operate the device unless it is installed inside an enclosed container.

Drain and depressurize the container being cleaned.

Close all of the openings on the container (e.g. inspection openings).

When operating the device, adhere to the switch-on and switch-off procedures (see sections 6.3
Switch-on Procedure and 7.2 Switch-off Procedure ).

There is no need for the device to be run in.

The following operating states of the device are NOT permitted:
– Operation of the device without cleaning agent.
– Immerse the device in the product of the production process.
– Operation of the device outside the permitted parameters
(see
section 3.3 Technical Data ).

Immediately stop operation in the event of leaks outside the container.

Refrain from any type of work which compromises the safe and reliable function of the device.

Immediately inform the operating company of any changes to the device or the plant that may impair
its safety.