AWH TANKO JM100, Руководство по эксплуатации и установке, Страница: 78 / 104

Jet Cleaner TANKO-JM
68/90 Translation of the original Operating / Installation Instructions 2016/12 7 Maintenance
17. Remove the screwed parts from the vise.
The device is fully assembled and ready for installation (see section 5.2 Installation ) on the plant.
7.4.4.3 Assembling the JM800 Device
The item numbers shown in brackets refer to the Figure 7.5-3: Internal construction of the
JM800-G13 .
The tightening torque values for the screw connections required for assembly are listed in the
Table 7.5-7: JM800 tightening torque values .
1) Assembly - Cleaning Head
1. Clamp the nozzle carrier (22) in the vise. In doing so, the thread of the bevel gear wheel for nozzle
carrier (21) faces upwards.
2. Press the sliding disk (09 white) into the nozzle carrier (22).
3. Insert the axle for nozzle carriers (20) with the thread facing upwards through the nozzle carrier (22)
into the sliding disk (09 white).
4. Insert the sliding disks (07 white and 10 blue) in the correct sequence on the axle for nozzle
carriers (20).
5. Screw the bevel gear wheel for the nozzle carrier (21) into the nozzle carrier (22) and tighten it with
a face wrench.
6. Check to see if the nozzle carrier (22) on the axle for nozzle carriers (20) is rotating freely.
7. Remove the screwed parts from the vise.
8. Clamp the shaft-axle connection (19) in the vise.
9. Screw the axle for nozzle carriers (20) with the nozzle carrier (22) and the bevel gear wheel (21) into
the shaft-axle connection (19).
10. Slide the hand lever of the assembly/disassembly tool for rotors with the flat side through the nozzle
bores in the nozzle carrier (22) and through the lateral bores of the axle for nozzle carriers (20).
11. Tighten the screwed-in axle for nozzle carriers (20).
12. Screw and tighten the rotor shaft (15) into the shaft-axle connection (19).
13. To secure the connection against loosening, screw the threaded pins (25) into the shaft-axle
connection (19) and tighten them.
2) Assembly - Actuator Unit Assembly Unit
1. Place sliding disks (09, 08, 09) in sequence into the bevel gear wheel for housing (18).
2. Screw the bevel gear wheel for housing (18) with the sliding disks into the base of the housing (03).
3. Clamp the base of the housing (03) with bevel gear wheel for housing (18) and sliding disks (09, 08, 09)
in the vise. The bevel gear wheel for housing (18) faces upwards thereby
4. Use a face wrench to tighten the bevel gear wheel for housing