![background image](http://html1.mh-extra.com/html/avtech/avrq-5-b/avrq-5-b_instructions-manual_3034555034.webp)
For positive pulse mode, the “AMP1” front-panel setting must be set to a positive value
AND
the daughterboard must be installed in the socket so that it is in the left-most
position (when viewed from the DUT area door opening), closest to the socket lever,
like this:
DAUGHTERBOARD INSTALLED FOR
POSITIVE
PULSE OPERATION
In this configuration, pins J2:1 to J2:16 on the daughterboard mate to pins 5 to 20 of the
ZIF socket, and pins J1:1 to J1:16 on the daughterboard mate to pins 36 to 21 on the
ZIF socket. The positive pulse generator (ZIF pin 20) applies a pulse to J2:16, and this
pulse is also fed to the BNC connector on the panel through a daughterboard track to
J2:12 / ZIF pin 16. VCC2 is applied to ZIF pin 36 / J1:1. Chassis ground (GND2) is
provided at ZIF pins 21-24 / J1:13-16. The ground-referenced logic output is provided
at ZIF pin 29 / J1:8.
For negative pulse mode, the “AMP1” front-panel setting must be set to a negative
value
AND
the daughterboard must be installed in the socket so that it is in the right-
34
Unused space
in this area
Daughterboard is
installed as far to the
left as possible, close
to the socket lever.
These silkscreened arrows must
always point in the same direction.
Содержание AVRQ-5-B
