![background image](http://html1.mh-extra.com/html/avtech/avrq-5-b/avrq-5-b_instructions-manual_3034555063.webp)
The 1 kilohm impedance still results in a large voltage spike. If the pullup resistance is
dramatically reduced to 50 Ohms, the coupled voltage spike is also reduced:
Top: +1.5 kV HV pulse
Bottom: Logic out into open circuit
no DUT, R2 = 1kΩ, 100 ns/div
Top: -1.5 kV HV pulse
Bottom: Logic out into open circuit
no DUT, R2 = 1kΩ, 100 ns/div
This is not usually a practical circuit setup for a real DUT (since they are not normally
capable of driving 50 Ohm impedances, unless they are gate drivers), but it lets us
estimate the parasitic capacitance present on the daughterboard. A spike on the order
of 2V is observed, giving:
I = C dV/dt
C = I dt / dV
C = (2V / 50 Ohms) × 4 ns / (1500V × (90% - 10%))
C = 0.13 pF
This is a physically reasonable value for the parasitic capacitance between the high
voltage pulse and output logic signal lines on the daughterboard.
The effects of capacitive coupling will be especially significant for devices with open-
collector outputs when the outputs are passively pulled high through a resistance of a
few kilohms or higher. For example, if an HCPL-2601 is tested using R2 = 1 kΩ (and R6
= R9 = R10 = 0Ω), the logic outputs are quite similar to the results on the previous page
(which used no DUT, and R2 = 1 kΩ):
63
Содержание AVRQ-5-B
