![background image](http://html1.mh-extra.com/html/avtech/avrq-5-b/avrq-5-b_instructions-manual_3034555077.webp)
PROGRAMMING YOUR PULSE GENERATOR
KEY PROGRAMMING COMMANDS
The “Programming Manual for -B Instruments” describes in detail how to connect the
pulse generator to your computer, and the programming commands themselves. A
large number of commands are available; however, normally you will only need a few of
these. Here is a basic sample sequence of commands that might be sent to the
instrument after power-up:
*rst
(resets the instrument)
trigger:source internal
(selects internal triggering)
frequency 10 Hz
(sets the frequency to 10 Hz)
pulse:delay 1 us
(sets the delay to 100 ns)
volt1 +1.5 kV
(sets the HV PULSE amplitude to +1.5 kV)
volt2 5.0
(sets VCC2 to +5.0V)
output on
(turns on the output)
The output will turn off automatically 90 seconds later, if no further commands are sent
before then.
For triggering a single event, this sequence would be more appropriate:
*rst
(resets the instrument)
trigger:source hold
(turns off all triggering)
volt1 -1.5 kV
(sets the HV PULSE amplitude to -1.5 kV)
volt2 5.0
(sets VCC2 to +5.0V)
output on
(turns on the output)
trigger:source immediate (generates a single non-repetitive trigger event)
trigger:source hold
(turns off all triggering)
output off
(turns off the output)
To set the instrument to trigger from an external TTL signal applied to the rear-panel
TRIG connector, use:
*rst
(resets the instrument)
trigger:source external
(selects internal triggering)
pulse:delay 1 us
(sets the delay to 100 ns)
volt1 -1.5 kV
(sets the HV PULSE amplitude to -1.5 kV)
volt2 5.0
(sets VCC2 to +5.0V)
output on
(turns on the output)
These commands will satisfy 90% of your programming needs.
77
Содержание AVRQ-5-B
