10
CAUTION:
The System Select Switch has no function in the AV-CM4ʤ-VCUC as all the output resolutions are
dictated by the computer to which it has been connected
Power adapter
This equipment is equipped with a 12V/2A DC power supply. Insert the power supply according to the requi-
rements, turn on the power switch.
Power On
Pan-Tilt will rotate to the maximum position of top right after the camera started, then it returns to the
center, the process of initialization is finished. The camera will show its current IR-channel setting and IP
Address on the osd (Note: If the position preset 0 has been stored, the position preset 0 will be called after
initialization). From this point onwards the user can control the camera with the supplied IR remote control,
Serial control using RS232/RS485 or over IP using Visca over IP
RS232 Interface
System Select Switch
www.avonic.com
If you are not using the RS232 9-pin D-Sub female to DIN -8 male cable supplied in the box, connect the
controller to the back of the camera as is shown in the respectively figures below for Windows DB-9 and
Mini-DIN-8. The photo below is a picture of the RS-232 interface of the back of the camera.
