29
PTZ Speed:
It is possible to increase the maximum pan and tilt speed, this can be useful in a con-
ference system where quick action is necessary. The camera will produce slightly more
noise when this setting is set to ‘high’.
Low Power Mode:
The camera will go in stand by mode to reduce its power when this mode is enabled.
Note: In order to reduce the power the camera uses, the camera will shut down the IP Port.
To activate the camera again, use a serial connection and a remote to set off the Low
Power Mode.
Preset Pan and Tilt-
Speed:
This mode affects the speed to which the camera is switching from one preset to another
when you use your (remote) controller. The higher the number, the faster it will switch.
Zoom Speed:
You can set the speed to which the camera will zoom in to the image. The higher te num-
ber, the faster the camera will zoom in. This works
only
when the remote controller is used
to control te camera.
P/T/Z
Reboot
If any changes made, these settings will only take effect after a reboot of the camera.
www.avonic.com
