Avocent SPC 800, Инструкция по установке и эксплуатации

Страница: 22 / 52

16
SPC Installer/User Guide
NOTE:
For security, you may wish to change the passwords for the predefined usernames.
You may add up to 57 additional users.
By default, only the Admn user may perform administrative operations such as
adding/deleting usernames and command privileges, changing passwords and
displaying port and user information. The Admn user may also view the status
of all SPC ports, access the control screen and control power to all ports.
By default, the Gen1 and Gen2 users may view the status of all SPC ports,
access the control screen and control power to all ports. The administrator may
change these privileges.
The administrator creates additional usernames with the Add User command,
then uses the Add Port command to grant these users the right to view the
status of and control power to specific SPC ports. The administrator uses the
Set Show command to grant control screen access to additional users.
The administrator may grant administrative privileges to another user with the
Admnp command. This command may also be used to remove administrative
privileges previously granted to another user. This feature allows the SPC to
have more than one administrator-level user.
Additional usernames must contain from 1-16 characters; spaces are not
allowed. A username is not case sensitive. Passwords may contain up to
16 characters, and are case sensitive. A password is not required for an
additional user. The administrator may change a password with the Set
Password command.
For security, when a password is typed, either blanks or asterisks appear on
the screen instead of the typed password characters.
See Administration Commands in this chapter for more information about
commands that create and manage usernames.
NOTE:
SPC usernames are distinct from CPS usernames.
Logging In
To log in to the SPC:
1. Initiate a Telnet session to the CPS port with the SPC connection. Enter
your CPS username and password, if required.
2. After receiving the Connected to port ... banner, press the Enter
key twice. The following appears, where x.x is the firmware version: