Avocent SPC 800, Инструкция по установке и эксплуатации

Страница: 37 / 52

Chapter 3: Operations
31
The following command blanks the password for the user named JaneDoe:
SPC: set password<Enter>
Username: janedoe<Enter>
Enter New Password:<Enter>
Verify New Password:<Enter>
Enabling and disabling confirmation for control
screen operations
The Set Screen command enables or disables a confirmation query when
requesting port power changes on the control screen. When the Confirm option
is set, the user is prompted with Are you sure? (Y/N) when an on, off or reboot
operation is initiated on the control screen. When the Noconfirm option is
set, the requested operation is completed immediately. The default value is
Noconfirm. The Set Screen setting applies to all usernames.
To enable or disable confirmation for control screen operations:
At the command prompt, enter set screen , followed by confirm or noconfirm .
Press Enter .
If you omit the confirm/noconfirm parameter or spell it incorrectly,
the command aborts with the message:
SET SCREEN options are
NOCONFIRM CONFIRM
Example
The following command enables control screen confirmation queries:
SPC: set screen confirm<Enter>
Granting and removing administrative privileges
The Admnp command grants or removes administrative privileges for
usernames other than the predefined Admn user. This command allows an
SPC to have more than one administrative-level user. You cannot remove
administrative privileges from the Admn user.
To grant or remove administrative privileges for a username:
At the SPC: prompt, type admnp , followed by on or off , optionally followed by
a username. Press Enter .
If you do not specify a username, you are prompted for it (Username:).