Avocent SPC 800, Инструкция по установке и эксплуатации

Страница: 17 / 52

Chapter 2: Installation
11
Rack Mounting
The SPC rack mounting hardware consists of two mounting brackets and four
sets of screws, washers and nuts. Attach the mounting brackets to the top and
bottom of the SPC using the supplied hardware. Then, attach the SPC to your
rack, using your screws, washers and nuts.
To rack mount the SPC:
1. Attach one mounting bracket to the top flange of the SPC with one set of
screws and washers through each of the slots in the bracket, as shown in
Figure 2.2. Secure each screw with a nut. The slots allow about 1/2 inch
of vertical adaptability.
Figure 2.2: Rack Mounting Bracket
2. Repeat with the other mounting bracket on the bottom flange of the SPC.
3. Attach the top and bottom brackets to your rack, using the round holes in
each bracket. The round holes may not align with the mounting holes in
your rack. In this case, you may use only one screw and washer set per
bracket to secure the SPC to your rack, as long as both top and bottom
brackets are attached to the rack.
A1
Input
Current