Avidity Science Pico PICO10T2, Руководство по эксплуатации

Страница: 13 / 40

Avidity Science, LLC Pico Water Purification System Operation Manual
Installation and Setup
7
Tubing
These are general guidelines for connecting the tubing to the Pico connectors.
•
Use a sharp blade to cut the tubing
•
Be sure the tube is long enough to allow for disconnecting and reconnecting during service.
•
Be sure tubing is clean and not cracked
•
Be sure there are no obstructions in the tube before connecting
•
Do not use excessive force when inserting tubing. Excessive force may damage the tubing resulting in
leaks.
•
Pull on the tube only once to be sure it is secured in the fitting
•
After pulling once, insert the wrench under the collet and push the tube into the fitting once more for
a secure fit.
Connect High or Low Pressure Feed Water Tubing
NOTE: Use the provided elbow connectors as necessary.
The 5/16-inch feed water tubing can be connected to the high pressure or low pressure inlet fitting
depending on the known feed water pressure.
NOTE: If the pressure is not known, connect the feed water tubing to the high pressure fitting. A water pressure
test will be conducted at the completion of the installation process to determine the required pressure.
Follow this procedure.
1. Measure and cut the length of the 5/16-inch feed water tubing needed between the water source
connection and the applicable feed water inlet fitting on the Pico unit. Add extra length to accom-
modate removal and reconnection of the tube.
2. Connect the check valve-end of the tubing to the applicable inlet fitting.
Feed water inlet. Low pressure, less than 1 bar [15 psi]
Feed water inlet, High pressure, greater than 1 bar [15 psi]