Avidity Science Pico PICO10T2, Руководство по эксплуатации

Страница: 11 / 40

Avidity Science, LLC Pico Water Purification System Operation Manual
Installation and Setup
5
8. Using a drill with a 10 mm masonry bit, drill four holes deep enough to insert wall anchors.
9. Insert the wall anchors.
10. Position the right bracket ( R ) slots over the anchors and secure the bracket with four anchor
screws.
Figure 3. Align and secure left and right mounting brackets.
11. Use the level to be sure the brackets are aligned so the Pico unit will be level when mounted.
12. Using two people, place the Pico unit onto the mounting brackets. Be sure the mounting holes on
the side of the unit align with the mounting slots on the brackets.
13. With one person holding the unit in place, secure the unit to the brackets with the 4 mm Allen
head screws.
Install Dispenser Tap
The Dispenser Tap can be installed in either of two ports. Installation in the upper port is good for bench
placement of the Pico unit where a large container can be placed on the bench as it is filled, but there will
be no access to the remaining water in the reservoir once the level drops below the dispense port.
Installing the port in the lower port is best if the unit is wall-mounted and all water in the reservoir will be
accessible.
Follow this procedure.
1. Remove the Dispenser Tap from its packaging.
2. Determine which port on the reservoir to install the Dispenser Tap and remove the plug.
3. Place a washer over threaded end of the Dispenser Tap. Be sure the beveled-side of the washer
faces the threads of the tap.
4. Insert the threaded-pipe end of the tap through the hole. Hand-tighten only.
5. Place a washer over the red plug with the beveled side facing the threads and insert the plug into
the unused port. Screw the plug into the hole until tightened. Make 1/4-turn past tight to ensure a
proper seal.
A
A
L R