Avid Technology S4, Руководство по установке

Страница: 30 / 60

S4 Installation Guide 24
Connecting and Attaching Display Modules
To install a Display Module:
1
Holding the Display Module near the chassis, connect power and Ethernet to the connectors on the bottom of the display. Use
the power cable and 12-inch Ethernet cable you fed through the back of each chassis earlier.
2
Locate the four rounded fasteners included with each Display Module that you unpacked when installing the mounting brackets.
3
There are two positions to mount the Display Module, low and high. Select a position, then attach the Display Module to a Dis-
play Module Mounting Bracket and secure it with the included mounting screws.
4
Repeat the previous steps to install other Display Modules.
Fill Panels, Compression Panels, and T-Strips
After installing modules add Fill Panels, Compression Panels, and T-Strips to secure the modules in place.
Installing Fill Panels
After all modules are installed (including Display Modules, if any), install Fill Panels. Fill Panels are available in different sizes to
fill empty chassis, to fill large and small slots, and to keep modules and panels aligned horizontally.
Mini Fill Panel
Fits behind or in front of a Master Joystick, Master Post, or Knob Module.
Fill Panel Small
Same size as Master Joystick, Master Post, and Knob Modules.
Figure 17. Connectors on the bottom of the Display Module
Figure 18. Attaching a Display Module to its mounting bracket (side view, smaller bracket shown)
Do not connect anything to the USB ports unless directly instructed to do so by an Avid Authorized Service provider.
Figure 19. Fill Panels: Mini Fill Panel (left) and Fill Panel Small (right)
Gigabit
Power
Ethernet RJ45
Fastener
Tool
M4x10 BCHS (7760-30535-00)
M2.5 Hex