Avid Technology S4, Руководство по установке

Страница: 25 / 60

Chapter 4: Hardware Assembly 19
Installing Master Section Modules
Installing the Automation Module is nearly identical to installing a Channel Strip Module.
Installing the Automation Module
To install the Automation Modules:
1
If you have not already done so, unpack the Automation Module and Master Module.
2
Remove the large black plastic covering from the opening in the back of the chassis where you plan to install the Master Module.
3
Hold the Automation module above its chassis and do the following:
• Connect the longest 2-pin Molex power cable in the chassis to the DC input on the side of the module.
• Connect the longest Ethernet cable to the Ethernet port on the side of the module.
4
Install the connected Automation Module into the chassis, making sure it sits fully into the frame and not on any cables
Figure 8. Power and Ethernet connectors on Automation Module
Figure 9. Automation Module in slot 1 of the chassis (cables not shown)
Ethernet
Power