AVG-CSK4K-44
5.2.4 RS232 Communication Commands
Note
:
1)
Please disconnect all twisted pairs before sending command EDIDUpgrade[X].
2)
In the
above commands, “[”and “]” are symbols for easy reading and do not need
to be typed into the actual operation command.
3)
Please remember to end the commands with the end
symbols “.” and “;”.
4)
Type the command carefully, it is case-sensitive.
Baud rate: 9600 Data bit: 8 Stop bit: 1 Parity bit: none
Command
Function
Feedback Example
System Commands
/*Type;
Query the models information.
XXXXX
/%Lock;
Lock the front panel buttons on the Matrix.
System Locked!
/%Unlock;
Unlock the front panel buttons on the Matrix.
System Unlock!
/^Version;
Query the version of firmware
VX.X.X
Demo.
Switch to the “demo” mode
, switch input and
output in sequence e.g. 1B1, 1B
2, …
4B3, 4B4,
1B1
… and so on
.The switching interval is 2
seconds.
Demo Mode
AV:01->01
IR:01->01
AV:01->02
IR:01->02
……
AV:04->04
IR:04->04
……
Operation Commands
[x]All.
Route signal from the input channel [x] to all
output channels
X To All. (X=01~04)
All#.
Route all input signals to the corresponding
output channels respectively like 1->1, 2->2
…
All Through.
All$.
Switch off all the output channels.
All Closed.
[x]#.
Route signals from the input channel [x] to the
output channel [x].
X Through. (X=01~04)
[x]$.
Switch off the output channel [x].
X Closed. (X=01~04)
[x]@.
Switch on the output channel [x].
X Open. (X=01~04)
All@.
Switch on all output channels.
All Open.
[x1]V[x2].
Route the AV signal from the input channel [x1]
to one or several output channels ([x2],
separate output channels with comma).
AV: X1-> X2
(X1/X2=01~04)
[x1]B[x2].
Route the AV and IR signal from input channel
[x1] to one or several output channels ([x2],
separate output channels with a comma).
AV: X1-> X2
(X1/X2=01~04)
[x1] R[x2].
Route the IR signal from output [x1] to input
[x2].
IR: X1-> X2(X1
、
X2=01~04)
Status[x].
Check the I/O connection status of output [x]
AV: Y-> X
(X=01~04, Y=01~04)
