AVG-CSK4K-44
7)
Plug the IR Receivers 3.5mm jack into the IR IN sockets on the HDBaseT
Receivers and plug in the IR Emitters to the IR OUT sockets (1~4) on the Matrix
Switcher to make up the IR Matrix
8)
Plug the phoenix connector in to the RS232 socket on the matrix, this will enable
the Matrix Switcher to be controlled via a PC or 3
rd
Party Controller
9)
Plug in a Patch lead from the router in to the Ethernet port on the Matrix Switcher
to control the Matrix Switcher via TCP/IP protocol
10)
Plug in the 24V DC Power supply adapter and tighten to secure. Once all
components have been connected and the installation is completed, switch on
the mains supply at the socket
Note:
1. Connect HDBT ports of Matrix Switcher and far-end HDBaseT Receivers with
straight-through cable. Do not install through patch panels, wall sockets etc.
2. IR receivers connected to IR IN should contain carrier. If needed, send the
RS232 command %0900. or %0901.to activate native carrier mode or force
carrier mode in the IR matrix between the Matrix Switcher and the far-end
HDBaseT Receiver.
4.4 Connection with the HDBaseT Receiver
The Matrix Switcher has 3 HDBaseT outputs which support PoC technology.
Connect HDBaseT Receivers to the pre-installed cabling. Plug the power supply in to
the power socket on the matrix, the HDBaseT Receivers will be powered by the
Matrix Switcher via PoC.
