AVG-CSK4K-44
IR Matrix
The IR signal is sent by an IR remote, then it is input to the HDBaseT receiver, then
to the corresponding zone of the matrix through the twisted pair, finally it is
transferred to the IR OUT port and received by the appropriate source device.
Switching Operation
:
Sending command (reference to
5.2 RS232 Control)
: [x1]R[x2].
x1: Corresponding to the 4 IR OUT ports of the Matrix Switcher, the IR
transmitter connected to this port can be placed at the IR receiving area of
output device or the Matrix Switcher itself.
x2: Corresponding to the zone (receive IR signal from HDBaseT receiver with IR
IN port, connects with IR receiver) number of the Matrix Switcher.
→ Example: Send command “3R2.”
to transfer IR signal received from zone 2 to
IR OUT port 3.
5.2 RS232 Control
5.2.1 RS232 Connection
Aside from the front control panel, the Matrix Switcher can also be controlled by a
3
rd
party control system/PC through the RS232 communication port. This RS232
communication port is a 3-pin phoenix connector. Use the supplied RS232 cable
(Phoenix to 9-pin D-Sub) to connect to the RS232 port to a PC, see as below:
