34
3. In
(2) Enable Time
,
the number from 00 to 23 represent the time in 24-hour clock.
Select the time and click the block you want to activate or deactivate the alarm
function. When it is deactivated the color of the block turns white.
4. In
(3) Conditions
, you can set “
Trigger if any
” to activate if it falls to one of the
conditions or “
Trigger if all
” to activate if it falls to all conditions.
-
In Camera section, select and click on the camera number (01 to 16) in
Motion Detected
and
Video Loss
to set the condition for the system to
alarm.
-
In
Missing and Suspicious Object Detected
, click the camera number
(01 to 16)and select the certain object on the screen (right click on camera
number for detailed setting)), and when the certain object is missing or
doubtful, the system will alarm.(see also Chapter 5.9.12)
-
In
Scene Change
, click the camera number (01 to 16) and when the camera
is been moved, the system will alarm.
5. In
(4) Sensor
, select and click on the sensor number (01 to 16) to set the
condition for the system to alarm. If the sensor normal status is high, set the
sensor condition to low (see
chapter 4.7 step #4
).
-
Enable/disable the
Hard Disk Failed
check box, to detect the condition of
the hard disk.
-
Enable/disable the
POS Keyword
check box, to scan the data from the POS
if it matches the keyword (see also
Chapter 4.9.11
).
-
Enable/disable the
Alarm Message
check box, to active with external alarm
message by your own program. For the detail configuration, please contact
the local reseller.
6. In
(5) Alarm Reset
, click the camera number (01 to 16) to set the reset condition
of alarm. Once alarm is reset, all alarm action will stop at the moment. If the
sensor normal status is high, set the sensor condition to low.
7. In
(6) Action
,
you may now set the alarm action for the system to perform when
the alarm condition is activated.
-
Launch E-Map
Display mini Emap screen.
-
TV Out
Switch to only display the video on TV from where the alarm is activated.
-
Enlarge Camera View
Switch to only display video in Preview/Advanced mode from where the
alarm is activated.
-
Relay Output
Set to enable/disable the relay operation when the alarm is activated and to
extend additional time in second before it stops the relay operation (see also
Chapter 4.9.1
).
-
Play Warning Sound
Play alarm sound. To setup click
Detail
(see also
Chapter 4.9.2
).
-
Make Phone Calls
Dial and contact the number in the list. To setup click
Detail
(see also
Chapter 4.9.3
). To use this feature, the PC must have a voice modem
connected to it. The supported audio system is only 8KHz and 16Bit mono.
