50
TRIGGERED TEXT
A Triggered Text is a data string that associates with one of the 16 alarms or with external RTS alarm. When the
alarm is triggered by a source, the associated string is sent out and/or displayed, if enabled respectively. Each
Triggered Text can contain up to 40 printable ASCII data. If non-printable data (control code) is included, each
control code occupies 3 printable spaces. Therefore, only 13 control codes maximum can be programmed in one
Triggered Text. To program the TRIGGERED TEXT, go to the “ALARM OUTPUTS” Tab . Select desired ALARM NO or
RTS for external alarm. Then select TRIGGERED TEXT section.
RegCom-Pro POS / Cash Register Interface
Figure 101: Triggered Text Section
ALARM DURATION
This is the amount of time in seconds that the alarm will remain activated once it is triggered. The selections for alarm
duration are: PULSE, 1, 3, 5, 10, 15, 20, 30, 60, 120, 180, and 240 seconds. (PULSE sends a 200mS alarm pulse to the
alarm device.)
To select the amount of time in seconds that you want to program the alarm duration, select “ALARM OUTPUTS” Tab
then select ALARM OUTPUTS section and then select ALARM DURATION,PULSE, 1, 3, 5, ..., 240, in ALARM
DURATION drop-down menu.
NORMAL STATE
Choices: NO (Normally open), NC (Normal closed)
There are two choices: NO (normally open) or NC (normal closed). These selections determine whether the alarm
outputs will act as a normally open switch or a normally closed switch.
To select the Normal State that you want to program, select “ALARM OUTPUTS” Tab then select ALARM OUTPUTS
section and then select NO or NC in NORMAL STATE drop-down menu.
To select the alarm trigger that you want to program, select “ALARM OUTPUTS” Tab then select ALARM OUTPUTS
section and then select ALARM TRIGGER ,1, 2,..., 23, 24, RTS in ALARM TRIGGER EX.. drop-down menu.
4. PROGRAMMING
