Avaya CS 1000, Основы

Страница: 51 / 270

Figure 21: Example of a cell center boundary
Use the following procedure to mark and label the cell boundary.
Marking and labeling the cell boundary on the floor plan
1. Mark each office within the cell that is isolated from the office area.
2. Label subsequent critical points on the floor plan with the following symbol.
3. Mark the cell contour on the floor plan by tracing a contour line through the Xs with
a marker.
4. Trace the cell boundaries and cell centers with colored markers.
Use the following procedure to identify new critical points.
Identifying new critical points
1. Identify one new critical point slightly inside of where the cell boundary meets the
outside wall.
In Figure 22: Example of new critical points (P8 and P9) on page 52, this new
critical point is P9.
2. Identify another new critical point which is adjacent to the first new critical point.
Locate this critical point on the opposite side of the cell boundary area.
In Figure 22: Example of new critical points (P8 and P9) on page 52, the cell
boundary area is IC1 and the new critical point is P8.
System deployment
SIP DECT Fundamentals October 2012 51