Avaya Compact Contact Center, Руководство по установке

Страница: 20 / 70

Page 20 - Server PC Setup – NT4 PC Configuration
Advantech PCI Wallboard Card
Card settings: SW1 (CH1) = ON
SW1 (CH2) = ON
JP1 =
485
JP2 = 485
To change the settings (NT systems):
1. Ensure that the card is not plugged into the PC. If the card is still in the PC shut
down the PC and remove the power leads before removing the card, otherwise the
hard drive may become corrupted.
2. Insert the Advantech PCI drivers utility installation diskette 1 into drive A.
3. Select
Start , and then click on Run.
4. At the next screen type A:\setup.exe and click on OK .
5. At the welcome screen click Next.
6. At the software license screen agreement screen click Yes .
7. At the destination screen accept the defaults and click Next .
8. At program folder accept the defaults and click Next .
9. When prompted insert disk 2 and click on the OK button.
10. At set-up complete screen and click Finish .
11. At Advantech PCI serial Service Manager screen make sure that the Start/Stop
service control is Install and Start Service and then click OK .
12. Click OK at the next screen.
13. Shut down the computer and install the card into PCI SLOT 4.
To change the settings (Win2000 systems):
1. Ensure that the card is not plugged into the PC. If the card is still in the PC shut
down the PC and remove the power leads before removing the card, otherwise the
hard drive may become corrupted.
2. Insert the CCC CD, do not let it auto run but simply open the CD
3. Locate and open the folders
PRIRS485 card drivers for WIN2K/ICOM_DRV and
click on SETUP.EXE .
4. At the welcome screen click Next.
5. At the software license screen agreement screen click Yes .
6. At the destination screen accept the defaults and click Next .
7. At program folder accept the defaults and click Next .
8. When prompted insert disk 2 and click on the OK button.
9. At set-up complete screen and click Finish .
10. At Advantech PCI serial Service Manager screen make sure that the Start/Stop
service control is Install and Start Service and then click OK .
11. Click OK at the next screen.
12. Shut down the computer and install the card into PCI SLOT 4.
If applicable (Server and Client on different PCs), you must now configure the Client
PCs (see pages 24, 25, 25 and 26 as appropriate). Alternatively, where Server and
Client are on the same PC, you may now install the appropriate CCC licenses and
applications (see pages 44 and 27 respectively).
Page 20 - Server PC Setup – NT4 Compact Contact Center Installation Manual
PC Configuration 40DHB0002USBG Issue 4a (05/29/2003)