PC Configuration
Server PC Setup – NT4 - Page 19
Installation of Wallboard Card (Ferrograph only)
Ensure that the Wallboard Card's switches and jumper setting are as listed below. The
location of the switches and jumpers is detailed in the Installation Manual that should
be supplied with the PCB. If the Installation Manual is not supplied with the PCB it can
be obtained from www.advantech.com.
Advantech ISA Wallboard Card Installation
Card Settings: -
JP1 (ch#1) 485
JP2 (ch#2) 485
JP3 (ch#1) IRQ9
JP4 (ch#2) IRQ5
JP5 (ch#1) On
JP6 (ch#2) On
To change the settings on Windows NT PC:
1. Click
Start
, highlight
Settings
and then click
Control Panel
.
2. Double click the
Ports
icon.
3. Highlight
Port 3
and then click
Settings
.
4. At the next screen click
Advanced
.
5. Change Base I/O port address to
03E8.
6. Change
IRQ
to
5
, then click
OK
.
7. Click
Don't restart Now
and then click on
OK
.
8. Highlight
Port 4
and click on
Settings
.
9. At the next screen click on
Advanced
.
10. Change
Base I/O Port Address
to
02E8.
11. Change
IRQ
to
9
and then click
OK
.
12. Click Restart Now.
To change the settings on Windows2000 Pro:
1. Right click on
My Computer
and select
Manage
.
2. Open
Ports (COM & LPT)
, highlight required port and right click.
3. Select
Properties
and then click on the
Resources
tab.
4. Remove the tick from
Use automatic settings
.
5. Highlight
Interrupt Request
and select
Change Settings
.
6. From
the
Setting based on
pull down menu set
IRQ
to
5
.
7. Highlight
Input/Output Range
and select
Change Settings
.
6. From
the
Setting based on
pull down menu select
03E8
, then click
OK
.
Compact Contact Center Installation Manual
Server PC Setup – NT4 - Page 19
40DHB0002USBG Issue 4a (05/29/2003)
PC Configuration
