Avaya AP 8120 series, Руководство по установке

Страница: 38 / 176

The mounting bracket is designed to use wall anchors with threaded section diameters ranging
between 3.5 mm and 4.5 mm. If wall anchors have threaded diameters greater than 3.5 mm,
only the two mounting holes marked ‘A’ may be used. If wall anchors have threaded diameters
of less than 3.5 mm, the holes marked ‘A’ and the holes marked ‘B’ may be used. All wall
anchors must have a head diameter of less than 10 mm or the wall mounting bracket cannot
be installed over them.
Perform the following procedure to mount a wireless LAN access point on a wall:
Procedure
1. Locate the appropriate position of the wall anchors. The wall anchors should be 95
mm apart horizontally and 80 mm apart vertically.
The wall bracket is designed to use a minimum of 2 anchors and a maximum of
4.
2. Install the screws into the wall anchors but do not seat them fully, leave at least a 2
mm gap between the screw head and the wall.
Indoor access point installation
38 Avaya WLAN 8100 Installation – AP 8120 Series April 2012
Comments? infodev@avaya.com