Avanzini DRAGO D1/M, Инструкция по эксплуатации и обслуживанию

Страница: 96 / 104

CHAPTER 8
Instructions, use and maintenance manual
Page 96
PROBLEM CAUSE SOLUTION
RED DISPLAY WITH
“- - - -”
• 4 lines appear on the red display .
To replace the probe it is always necessary to disconnect the
current (by switching off the main switch and disconnecting the
pl g , replace it and connect the c rrent to the entire system
again.
IMPORTANT:
if you replace the probe by simply turning off the Drago
Baby Six control panel but without disconnecting the
current from the entire system, the probe will not read
the T° inside the oven and the red display will continue to
show 4 lines
.
GREEN DISPLAY:
THE SET T° DOES
NOT INCREASE
The T° set on the
green display does not
increase even if
is held down,
but if is pressed
the T° decreases.
The maximum safety
T° is too low. • Get the maximum safety temperature to 360°c-400°c
according to the instructions.