Avanzini DRAGO D1/M, Инструкция по эксплуатации и обслуживанию

Страница: 24 / 104

CHAPTER 3
Instructions, use and maintenance manual
Page 24
3.1.1. ELECTRICAL CUT-OUT SWITCH
PICTURE DESCRIPTION
The Customer is responsible for positioning, upstream the insertion
point of the power supply line of the machine in the electrical
distrib tion system of the installation site.
onnection to the power s pply so rce has to ta e place thro gh a
dedicated line made available by the Customer; said line must be
protected by a disconnector switch with s itable brea ing capacity.
he switch can be loc ed in the open closed position
by means of a padloc .
The switch must be disconnected in case of:
•
electrical ha ard on the machine or on the plant.
• mechanical intervention on the machine or on the plant;
• electrical intervention on the machine or on the plant.
3.1.2. MAIN SWITCH
PICTURE DESCRIPTION
On the left side of the Drago Baby Six control panel is placed a main
switch that allows to t rn on off the control panel.
The main switch must be pressed in case of:
•
electrical ha ard on the machine or on the plant.
• mechanical intervention on the machine or on the plant;
• electrical intervention on the machine or on the plant.
3.1.3. MAXIMUM SAFETY TEMPERATURE
he ma im m safety temperat re programmed for the b rner ma es it possible to completely switch it off when
said temperat re is reached and detected by the probe inside the oven itself. I I I I s.r.l. presets
the val e of the safety temperat re at , and recommends to not change this val e. owever, sho ld the
c stomer wish to ma e changes and program a new val e, the reg lation proced re is described in the relevant
paragraph of this man al.