AVANT 735 2020, Руководство оператора

Страница: 75 / 140

Avant 735 Operating instructions
75
.
Ignition key
The ignition key can be switched into the
following positions:
1.
• (OFF) Shut down the loader engine

Ignition key can be removed
Most electric systems of the
loader are switched off.
However, some lights may not
be connected through the
ignition switch. To switch all
systems off, turn off the battery
main switch whenever leaving
the loader unattended.
2.
ON Engine run

The electric systems of the
loader can be used.
3.
Engine pre-heat

See starting procedure for
more information.

When released from this
position, the key switch will
return to ON.
4.
Starter run

Start the engine

When released from this
position, the switch will return
to ON.
.
To start the engine
1.
Perform daily checks (see Maintenance & Service
on page 99)
2.
Turn the battery disconnect
switch to ON
3.
Sit on the driver's seat, adjust seat, and fasten
seat belt
4.
Move the hand throttle lever
to approximately ¼ throttle
5.
Make sure that auxiliary hydraulics is switched off
(lever in neutral position), 51.
Do not press on the drive pedals.
6.
Turn the ignition key to the right, to ON position.
Signal lamps on the dashboard will light up briefly
for self-check. Oil pressure and charge indicator
lights will remain lit.
In cold conditions and when
the loader engine is cold, wait
until the glow plug indicator
light on the dashboard
switches off.
7.
Turn the ignition key further to the right until the
engine starts. Release the key to position ON
immediately when the engine runs.
Do not actuate the starter for more
than 10 seconds at a time. If the
engine does not start, wait for one
minute before repeating attempt. If
the engine does not start after a
few attempts, or runs poorly, see
troubleshoot on page 131 and the
engine owner’s manual.