AVANT 735 2020, Руководство оператора

Страница: 51 / 140

Avant 735 Controls and options of the Loader
51
.
Control of loader boom, auxiliary hydraulics and other functions
Most of the functions of the loader are controlled with the controls at the right side of the operator: Boom and
bucket movements, auxiliary hydraulics (attachments), auxiliary hydraulics pump speed etc., depending on loader
model. Following paragraphs show the different functions.
1. Control lever of boom and bucket
The loader boom and bucket are controlled with the multi-function lever (joystick) sideways (tilt) and back &
forward (boom up & down). In addition, the boom floating is controlled with the joystick

Pull backward to lift the
boom

Push forward to lower the
boom

Push left to raise the tip of
the bucket (filling)

Push right to lower the tip of
the bucket (emptying)
2. Control lever of auxiliary hydraulics (hydraulically operated attachments)
Hydraulically operated attachments are connected to the loader using the multi connector system, for more
information see page 90.

Operation directions depend on the attachment used.

When using an attachment for the first time, carefully
move the lever to test and check the operating direction
of the attachment.

For continuous operation of rotating attachments, turn the
lever to direction 1 set it to its locking position.

If operating the buttons of the electric joystick, this lever will
not move. Either the lever or the buttons can be used to
control the attachment as needed.
When you operate attachments that require continuous flow,
such as attachments with hydraulic motors, it is important to
have the control lever in fully engaged position. If the control
valve is not fully open, restricting the flow of hydraulic oil,
hydraulic system may overheat quickly.
If necessary, adjust the locking plate so that the lever is
locked to fully open position.