AVANT 735 2020, Руководство оператора

Страница: 42 / 140

Lift capacity Avant 735
42
.
Rated operating capacity
To easily determine how much load the loader can
handle safely, a table of the tipping load and a
calculated Rated Operating Capacity (ROC) is
shown in the adjacent label. The label is also visible
from the driver's seat.
Rated operating capacity depends on type of use of
the loader:

In bucket and general application the rated
operating capacity is 50% of tipping load

In pallet fork application the rated operating
capacity is 60% of tipping load
The information shown in the table is the worst case
minimum load, with the conditions listed below.
Actual lifting capacity could be significantly higher, or
it may be lower, depending on terrain conditions,
available lifting force, and load distribution. Adding or
removing counterweights will affect the indicated
ROC.
The load charts help you to estimate the weight of
the load that can be lifted with the loader without
tipping over on firm, stable ground. They describe
the loads that can be handled at different positions of
the loader boom.
The ROC label below shows the lifting capacity with
pallet forks in different positions of the loader boom.
The lifting capacity of the loader depends on the
horizontal distance between the center of gravity of
the load and the front axle of the loader.
When the load is lifted off from the ground, the loader
boom moves further away from the loader,
decreasing the stability of the loader. At the
horizontal position of the loader boom the load will be
the furthest away from the loader, and the tipping
load is the lowest. When the telescopic boom is
extended the tipping load is further reduced.
.
The ROC table is valid, when:

The ground is firm and level

Loader is stationary or driven max 2 km/h, with
smooth and slow control movements

Driver weighing 75 kg is seated on the driver’s
seat

Load is distributed evenly on pallet forks, with
the load centre of gravity at 500 mm from the
vertical part of pallet fork arms. The weight of the
fork attachment is taken into account in the
indicated load value