VWC-44
19
9.2
[Input Signal] selection
DVI input port can be DVI-D, VGA and HDMI (HDMI to DVI adapter is required) input signals.
When input HDMI signal into DVI port, it can support up to 4k/2k @30Hz with embedded audio.
The input signal from HDMI A port can be looped out for daisy chain connection. All the other input
signals can’t be looped out.
YPbPr video signal can be connected through VGA input port but YPbPr to VGA adapter is required.
9.3
[Scaling]: Display aspect ratio
9.4 [Output mode] selection
Output resolution shall be the same as projector native resolution to get the best video quality. Please set
the right output resolution before execute geometry alignment. Change output resolution will also change
the geometry alignment result.
User can press [Input] hotkey on front
panel to change input port. Message will
be showed on the screen.
User can select input port directly from IR
remote controller. Keypads on front
panel.
[Original AR]: To display with input source
aspect ratio
[Full Screen]: To extend the image to full
screen.
When implement edge blending or video
wall, please select [Full Screen].
Otherwise, it may show wrong result.
Please also set the right aspect ratio
setting in the projectors.
10 preset output modes.
Special output mode can be customized.
When the input is 50Hz refresh rate, the
output will be also 50Hz to maintain high
quality image.
When the input is 120Hz for active 3D,
the output will keep 120Hz but the output
resolution is limited to XGA & 720P only.
