P. 6
Installation Guide
Tachometer
input
in vehicles that use conventional coil systems. In Multi-coil systems,
the Tach wire may be difficult to locate: the negative terminal of an
injector may be used.
Note
: a Tach-programming procedure must be carried out after the
installation is completed.
3
GREY
(–) Hood Switch
input
Connect this wire to the installed Hood Pin switch supplied. This
input will disable or shut down the Remote Starter when the Hood is
up, and can also set off the Alarm.
4
ORANGE (+) Brake Switch
input
This wire must be connected to the Brake Light wire of the vehicle.
This wire must have +12 V only when the Brake Pedal is down.
This input will shut down the Remote Starter if the Brake Pedal is
pressed.
5
YELLOW (+) 12 V Parking
Light output
This wire provides a +12 V output and must be connected on the
vehicle to the Parking Lights wire that tests +12 V when the Light
switch is in the
ON
position.
Note
: ensure that the voltage does not decrease or increase when
the dimmer control switch is turned. If the voltage goes up or down,
find another Parking Light wire.
12-pin Accessories Harness
Wire
Colour
Function
Description
1
BLUE
(–) Trunk /
AUX 3
output
500 mA negative output. This output can be used to control
the Trunk release (1-sec. pulse), or it can be set to operate
as a constant output as long as the
TRUNK
button is held
pressed (for Sunroof or Window closure)
2
BROWN
(–) Lock
output
Programmable 500 mA negative output: 1/10-sec., 7/10-
sec. or 4-sec. pulse
3
GREEN
(–) Unlock
output
Programmable 500 mA negative output: 1/10-sec., 7/10-
sec., 4-sec. or double 1/4-sec. pulse (
ON
250 ms,
OFF
500 ms,
ON
250 ms).
4
WHITE /
BROWN
(–) Rearm
output
500 mA ground signal when the Doors are locked by
remote control. This wire will go to ground 1/2 sec. before
the
LOCK
pulse, and go out 1/8 sec after
LOCK
. The wire
must be connected to the OEM Arm wire (usually the Door
Pin).
Note:
The System will also give a Rearm pulse on this wire
when it shuts down the vehicle after a remote start.
5
WHITE /
GREEN
(–) Disarm
output
500 mA ground pulse when the Doors are unlocked by
remote control. Connect to the OEM Disarm wire of the
vehicle.
Note:
The system will also give a Disarm pulse on this wire
before every remote start.
This input should be used in vehicles with
positive-
switching
Door pins or Dome Light circuits. Connect to the
Dome Light wire that tests +12 V when a Door is open.
6
BLUE /
WHITE
(+) Positive
Door input Caution!
The installer should use
either
the positive
or
the
negative Door input. Never use both of them
simultaneously.
7
WHITE /
ORANGE
(–) Starter Kill
output
(armed
output)
This wire will provide a constant 500 mA output when the
system is
armed
(locked by remote control). It can be
connected to an external Starter Interrupt Relay.
This wire should be connected to a Single Pole Double-
