P. 18
Installation Guide
Siren Mute
When the Siren is sounding, pressing the
UNLOCK
button will stop the Siren. Note that this will not
unlock or disarm the vehicle.
Horn / Siren Mode
The System can be configured to use either the Siren or the Horn for sound signals and alarms.
Siren or Horn Chirps
The Siren can be configured to give the following signals:
Warning Chirps
:
Arming and disarming the car (
LOCK
or
UNLOCK
) will
not
cause the Siren to chirp. While
the vehicle is being armed, the Siren will chirp
3 times
if a Zone is active. After the
Alarm is set off, disarming the vehicle will cause the Siren to chirp
4 times
.
Full Chirps
:
Pressing the
LOCK
button will lock all Doors, arm the system and
•
cause the Siren to
chirp 1 time
if all Zones are inactive.
•
cause the Siren to
chirp 3 times
if a Zone is active.
Pressing the
UNLOCK
button will unlock and disarm the vehicle and:
•
if no intrusion was detected, the Siren will
chirp 2 times
.
•
if an intrusion was detected, the Siren will
chirp 4 times
.
Open Zone Notification
(see below):
If a Door is detected as
open
10 sec. after arming, the Siren will
chirp 3 times
.
Chirps disabled
: the Siren will not chirp under any circumstance.
Shock Sense and Warn-away Sense
Your System can react to a full shock by triggering the Alarm; it can also respond to a lighter shock
(30 % of the strength of a full shock) by giving a
Warn-away
: the Siren will chirp but no Alarm
condition will be triggered. However, when the Engine is running after a remote start,
the Shock
Sensor will not trigger an Alarm condition
, although it will still produce warning chirps if Warn-
away Sense is enabled.
Note
Although the Shock Sensor may not trigger an Alarm condition after remote starts, the
Door Zones and the Hood Pin-switch may generate one: the Door Zones and the
Hood Pin-switch are not disabled in any way after remote starts.
Resetting the System
The system is equipped with a reset function that allows the installer to erase all transmitter codes
from memory and return all the programming options to the factory default values. Resetting the
system is not a required process. Most of the time, you can avoid resetting by fixing the issue
directly at the root of the cause.
1.
Flash the Hood Pin switch (see Table 1)
– Once inside Programming Mode, you have 13 seconds to complete the next step.
2.
Press and release the Break Pedal 6 times (within 13 seconds from entering
Programming Mode).
3.
The
Parking Lights will flash 8 times
to confirm resetting.
Table 8: Resetting without a Valet Button