P. 10
Installation Guide
1. Turn the Ignition Key to the
IGNITION ON (RUN)
position.
2. Within 3 seconds, press and release the Valet Button (the L.E.D. will come on and stay
lit).
The System must exit Valet Mode before a Transmitter Programming procedure can be
carried out:
Getting out of Valet Mode
1. Turn the Ignition Key to the
IGNITION ON (RUN)
position.
2. Within 3 seconds, press and release the Valet Button (the L.E.D. will go out)
(See section
Valet Operation
, in the User Guide, for more details on the use of Valet Mode.)
As the System exits Valet Mode, you will have 30 seconds to carry out the Transmitter
Programming procedure before the Alarm rearms.
The Transmitter Programming Procedure
1.
Flash the Hood Pin switch (see Table 1)
– The Parking Lights will stay
ON
for up to 20 seconds.
– Before the lights go out, turn the Ignition Key to the
IGNITION ON (RUN)
position.
– Immediately turn the Ignition Key back to the
OFF
position.
Press and hold the
LOCK
button and keep it down until the
Parking Lights flash
5 times
quickly and the siren will chirp twice.
– The System has stored the code of the Transmitter into memory.
2.
To exit: close the Hood.
Table 2: Programming a Transmitter
To program a Transmitter
on the second vehicle for Multi-car Operation, you must press the
TRUNK
and
LOCK
buttons simultaneously (instead of
LOCK
or
UNLOCK
) in transmitter programming
procedure.
Entering Programming Options Mode
The System is equipped with three custom programming Modes that allow the installer to custom-
fit the system outputs according to installation requirements. The Programming Options are
designed to facilitate interfacing with all vehicle types. (See section
Table of Programming
Options
later in this Guide.)
1.
Flash the Hood Pin switch (see Table 1)
– The Parking Lights will stay
ON
for up to 20 seconds.
– Before the lights go out:
2.
Press and hold the Brake Pedal,
– And press one of the following buttons on the Transmitter:
•
LOCK
................to access Mode 1;
•
UNLOCK
.............to access Mode 2;
•
TRUNK
...............to access Mode 3.
The
Parking Lights
will
flash
and the
Siren
will
chirp
once, twice or three times to
confirm entry into a Mode.
3.
Release the Brake Pedal.
Table 3: Accessing modes
Note
The Unit will stay in the selected programming Mode until the Hood Pin-switch or the
Brake Pedal is pressed again.
Therefore take your time to make the proper
selection.
Pressing the Brake Pedal will take you back to the Programming Centre,
where you can select a different Mode.