12
7.
Output
signals
adjustment
7.3.
Notification
signals on the
output “Alert_1”
4
7.3.1
*"Heater started"
7.3.2
"Heater stopped"
7.3.5
"Heater started to burn"
7.3.6
“Heating finished
7.3.7
"Error occured"
7.3.8
Disable the output
7.4.
Notification
signals on the
output “Alert_2”
7.4.1
"Heater started"
7.4.2
*"Heater stopped"
7.4.5
"Heater started to burn"
7.4.6
“Heating finished
7.4.7
"Error occured"
7.4.8
Disable the output
7.5.
Signals on the
output “Status”
7.5.1
Heater operates (potential)
7.5.2
*Heater operates autonomously (from
battery, engine is off) (potential)
7.5.3
Heater operates autonomously
(double impulses with the frequency adjusted
by 6.7, applying settings 6.3-6.5)
5
7.5.4
Engine runs (potential)
7.5.5
Engine runs (RPM impulses)
7.5.6.
Ventilation is on during the heater
operation (potential)
7.5.7.
Ventilation is off during the heater
operation (potential)
7.5.8.
Disable the output
8.
Settings reset
8.1.1
Apply factory settings
9.
Heater errors
reset
4
9.1.1
Clear all errors in heater’s memory,
resulting heater unblocking
* Factory setting
Recommended settings marked in Italics
1
–Not recommended for vehicles released after 2008 year because the heater
startup is not guaranteed in 2 minutes. Using 3.1.3 mode you can save battery
energy at low temperatures, because the heater switches on cabin ventilation not
immediately after start, but after the coolant warms up to +30˚C.
2
–RCP turns off the heater if the battery voltage becomes lower than preset
3
– Setting is not recommended for cars equipped with direction indicators in rear-
view mirrors.
4
– Signals appear only during heater autonomous operation
