7
When the ignition is turned on, button pressing keeps the current
condition of the heater after the engine start. So, if the heater has operated
before the engine start, it may continue to operate after the engine start (in boost
heat mode). If the heater has been idle before the engine start, button press will
inform RCP doesn’t let the heater to start in boost heat mode after the engine
start. These functions are called quick enabling and disabling of boost heat
mode respectively. Being activated these functions act for the current ignition
cycle. Turning the ignition off cancels these functions.
Table 3
Button function
Ignition
status
Engine
status
Heater
status
Description
(how to use)
Heater immediate
start
Off
Not running Off
One-touch heater start
Heater immediate
stop
Off
Not running On
One-touch heater stop
One-time boost
disable
On
Not running Off
Quick disabling of boost
heat mode for short trips
One-time boost
enable
On
Not running On
Quick enabling of boost
heat mode in case of boost
heat mode disabling by
RCP settings or in case of
one-time disabling by the
button pressing
On
Running
Off
Boost extension
On
Running
On
This function lets the heater
keep working after the
engine has been switched
off. It is useful with short
stops in a trip.
When the engine runs, the button press is used to quickly enable of the
boost heat mode (if boost heat mode was disabled early) and for the function
called Boost Extension (if the heater operates in boost heat mode). Usually the
heater is turned off right after the engine stops. If you want stop the engine with
the heater keep working, you may use this button function. Boost extension
once activated will act while don’t you stop the heater manually or the heater
stops automatically when the coolant achieves working temperature.
Warning!
The parking heater must not be operated at filling stations, near
sources of combustible vapours or dust or in enclosed spaces
The fuel fired heater needs about 3 minutes to go to normal operation
after startup. If your trip is planned to be shorter, it is highly recommended to
use a button function called “one-time boost disable”. This preserves the heater
from premature clogging. Turn on the ignition, press the button, then start the
