10
Axess® Pro Series 3100
Owner Installation Instructions
Before Drive Unit Installation
The Axess® Pro Series 3100 is designed to operate
most industrial heavy duty roller shutters. The shutter
must be in good working condition and travel freely in
the guides.
Step 1 - Initial Check
Before commencing installation, check the following:
The shutter moves freely for the full travel in both
directions.
The mounting must be a solid construction (concrete,
brick or steel) and must be able to withstand the full
driving force applied to the shutter.
There is a 240V 10 Amp power point located within
one metre of the drive unit.
For full automatic operation an EasyBeam™ must be
fi tted to the logic console. The EasyBeam™ should
be positioned as close to the shutter as practicable.
Selecting the installation location
Overall dimensions of the opener are shown in
Fig. 04-
06.
When selecting the installation location, consider the
following:
Minimum distance between the shutter drum and
mounting plate needs to be more than 15mm and
less than 100mm.
Minimum distance between the drive unit and the
imposing structure is 10mm.
The overhead clearance needs to be at least
150mm.
Step 2 - Drive Unit Pre-assembly
The opener can be installed on either the right- or left hand
side of the shutter (when viewed from inside the building).
The timing assembly, mounting fl ange and drive shaft
needs to be assembled according to the installation side.
Assembling the opener for RIGHT- HAND installation is
explained below. For LEFT-HAND side installation, assemble
the parts from the other end.
Assemble the mounting fl ange with four M8x20
bolts and washers to the opener
(Fig. 07)
Insert the output drive shaft into the gearbox,
thread side fi rst as shown in
Fig. 07.
Secure the output drive shaft with the lock washer
and lock nut.
Finger tighten the lock nut* then lock it by securing
the position of the lock nut by bending one tooth
of the lock washer into the slot on the lock nut
(Fig.
07)
.
Line up the shaft of the timing assembly with the
keyway on the back of the drive shaft. Push and
secure the timing assembly with bolts ensuring the
cable gland is facing the motor.
NOTE:
The drive unit is not designed to be mounted
upside down. Gearbox damage will result.
* Finger tighten to lock nut, this will remove any
movement in the output shaft. Excessive tightening to
lock nut may cause damage to output shaft bearing.
1.
2.
3.
4.
•
•
•
1.
2.
3.
4.
5.
1
2
3
5
4
04
fi g
05
fi g
06
fi g
07
fi g
495mm
85mm
200mm
260mm
