equipment det
ails
156
equipment det
ails
157
the bowl by lifting and pressing down the
flush handle (fig. 9).
9a.
C-200 CWE & CS only:
Before using the
toilet it is recommended to flush some
water into the bowl by pressing and
releasing the flush button (fig. 9a).
10. The toilet may be used with the blade
open or closed. Pull valve handle towards
you to open (fig. 10).
11.
C-200 CW only:
After use, open valve
blade (if still closed) and flush, lift the flush
handle and press it down (fig. 11). After
flushing, close the blade by turning the
blade handle.
11a.
C-200 CWE & CS only:
After use, open
valve blade (if still closed) and flush, press
the flush button (fig. 11a).
After flushing, close the blade by turning the
blade handle.
The waste holding tank is located underneath
the toilet and is removed for emptying from
the outside of the vehicle through an access
door. A rotating pour out spout, automatic
holding tank vent, air release valve, valve
blade, carrying handles and hand grip are
incorporated in the waste holding tank. A
sliding cover guarantees optimal hygiene.
Emptying the Holding Tank
The holding tank capacity is approx. 17 litres
and the tank should be emptied when the
waste-level indicator lights up. The waste-level
indicator lights up when the holding tank
contains more than 15 litres of waste.
CAUTIon: Do not allow the holding tank
to become overfilled. See trouble shooting
section for emergency emptying procedure.
12. Open access door and remove the holding
tank. The holding tank can only be removed
when the valve blade is closed (fig. 12).
13. Carry the holding tank to a normal
household type toilet or other authorised
disposal point. Place the holding tank in
vertical position and rotate pour out spout
upwards (fig. 13).
14. Remove the spout cap. Grasp unit by
upper carrying handle nearest to pour
out spout. Place other hand on upper
rear hand grip so that vent button can be
depressed with the thumb while emptying.
This ensures a smooth outflow of the tank
contents. (fig. 14).
Note: Only depress the vent button when
pour out spout is pointed downwards.
Rinse the holding tank with clean water. For
preparing for use again, see steps 1 to 7.
Cleaning and maintenance
The lipseal and the seal of the automatic vent
are made of rubber and therefore these parts
need regular maintenance (depending on
frequency of use, once or twice a month).
Lipseal:
Remove the sliding cover. Open the
valve-blade by turning the blade-opener knob
anticlockwise. Clean the seal with water. Dry
the seal and grease with silicone spray/oil or
vegetable oil.
Seal of automatic vent:
Turn the automatic
vent 60° anticlockwise and remove gently.
Clean the seal with water. Dry the seal and
11a
13
15
12
14
CASSETTE C-200 CW AnD C-200 CWE &
C-200CS
The toilet section of the C-200 includes a
rotatable bowl, removable seat and cover, a
console with a flush handle/flush buttons,
a built in flush-watertank and a waste level
warning indicator. The valve blade handle is
located underneath the bowl.
Preparing for Use
1. Open access door pull retaining clip
upwards (fig. 1).
2. Remove holding tank by pulling straight
out. When holding tank hits the stop, tilt
front end downwards slightly and remove
(fig. 2).
3. Position tank vertically and swivel pour out
spout upwards (fig. 3).
4. Remove the cap of the pour out spout.
Add required quantity of toilet fluid
through pour-out spout then add approx.
2 litres of water through the spout to
cover holding tank bottom. Replace cap
and return pour out spout to its original
stored position (fig. 4).
Note: Warmer weather or longer intervals
between emptying the waste tank may require
additional toilet fluid. Use only Thetford toilet
fluid to achieve the best results.
Caution: never add toilet fluid directly into
toilet bowl.
5. Slide the holding tank into position
through access door (fig. 5).
6. Make sure the holding tank is secured by
the retaining clip. (fig. 6).
7. Open the waterfill door and add 50 ml of
Aqua Rinse. Aqua Rinse results in a better
flush and improves the hygiene of the
toilet. Then fill the watertank with fresh
water using a jerrycan or a hose. Tank
capacity is 7 litres (fig. 7).
operation
8. Turn the bowl in the most comfortable
position (fig. 8).
9.
C-200 CW only:
Before using the toilet it
is recommended to flush some water into
1
3
5
7
9
10
2
4
6
8
9a
11
