Rev. 4.0 13ELE2000 Page 3 /14
TV
DVB-T
This unit receives and decode DVB-T digital TV
transmission. Before you are able to watch TV, the TV
antenna must be prepared: for example, pointing the
antenna to face the direction of the nearby transmission
tower. If using active antenna (antenna amplifier), the
power to this antenna must be switched on.
Setting up
DVB-T system varies from one country to another. Check
and ensure that ‘Country’ is set corresponding to the
location of reception. Memorised TV station list will be
cleared when this setting is changed. To enter DVB-T
mode, tap upper left corner. Tap up, down and left right
arrows to navigate the menu, OK icon is on upper left
corner.
Automatic search
DVB-T broadcast usually provides more
stations than conventional analogue TV.
The Automatic Search function aids
finding all available stations: menu ->
Installation -> Automatic Search.
Fr
o
n
t
pa
n
e
l
Display Off – special feature
The display can be turned off by
pressing and holding
the
SEL button. In this mode, all other operations such as audio
and video output remain normal and active. To bring back
the display, tap the screen or depress any button. The GUI
page has a brightness icon on the upper right corner. This
can also be used to turn off the display. The feature is
useful when driving at night.
Angle
Use the SEL button to cycle through the selections. When
“Tilt” is displayed, use + and – to adjust the angle of the
display. When the desired angle is set, leave the control a
few seconds. The word “Tilt” is cleared from the display,
and the display angle is memorised. Be sure there is nothing
in the way of the movement of the display.
Release button
The motorized front panel control button is shown in the
right.
Short press
to fully extend it. Pressing during motion
will stop the movement. Please ensure SD card or disc is
fully inserted before closing up the front panel.
Spe
c
ia
l
Automatic power on upon reverse gear engagement – special feature
Where configured, the unit can power on automatically when the reverse gear on your vehicle is engaged. The reverse camera
video will be displayed automatically to aid reversing your vehicle safely. The process of powering on and showing the live
reverse camera video image will take a few seconds. The driver may wish to wait for this screen being displayed before
commencing reversing. When the reverse gear is disengaged, the unit will revert to the original operating status. If the unit had
been operating, the reverse camera takes priority over all AV entertainment until the reversing trigger is cleared.
Wait for next screen
Initiate channel search
TV -> menu -> System -> Country
Refer to status manual
Scanning channels
+ -