1)
Batteries
9.1
SAFETY PRECAUTIONS
Electrical Systems
Battery terminals and connectors should be firmly connected. Battery surfaces should be free of
moisture and dirt. Cell tops must be fully tightened if appropriate. When removing a battery
always remove the negative wire first. On re-connection, the negative should be connected last.
Switch off all appliances and lamps before disconnecting the battery.
2)
�
Always replace blown fuses with a correct rating equivalent. Fuses rated at 7 .5 amp may be
replaced with an 8 amp in case of difficulty in purchasing a 7 .5 amp fuse.
3)
Overload
Never overload any electrical circuit especially the 12 volt socket outlet. The rating of equipment
should be checked before connection.
4)
Shower Compartment Liibt
Ensure that water does not ingress into the light unit.
5)
Charier Unit
Keep the charger unit well ventilated and never allow material or bags to be in contact with the
unit casing since heat is emitted during operation.
6)
240 Volt Mains Operation
Before connecting supply, ensure that the contacts 1n both the plug and the socket are clean and
dry and ensure also that the hook-up plug is firmly located and locked into the socket. Ensure the
RCD is easily accessible at all times.
7)
Wirin2 Diwam
Wirings diagrams are found in the rear of this instruction booklet. If in doubt refer to these
diagrams and if necessary contact your local Auto-Sleeper dealer who will be pleased to answer
any of your queries.
Содержание 1993 Trophy
Страница 1: ...Auto Sleeper INSTRUCTION M A N U A L ...